Makita GA7040SF Manual de Instruções

1 ENGLISH (Original instructions) INSTRUCTION MANUAL DOUBLE INSULATION IMPORTANT: Read Before Using. Angle GrinderGA7030,GA7030S GA7040S GA9030,GA90

10 Thread wire wheel brush onto spindle and tighten with the wrenches. When using wire wheel brush, avoid applying too much pressure which causes over

11 When the resin insulating tip inside the carbon brush is exposed to contact the commutator, it will automatically shut off the motor. When this occ

12 12345678910111213235678910211412113*1 Do not use Supper flange and Ezynut together.14151415*2 Use Inner flange 78 and Outer flange 78 together. (Au

13

14

15

16 Makita Corporation Anjo, Aichi, Japan 884649A937

2 ENGLISH (Original instructions) SPECIFICATIONS Model GA7030/GA7030S GA7040S GA9030/GA9030S GA9040S Depressed center wheel diameter 180 mm 230 mm S

3 6. Do not expose power tools to rain or wet conditions. Water entering a power tool will increase the risk of electric shock. 7. Do not abuse the

4 and/or serious injury. 2. Operations such as polishing are not recommended to be performed with this power tool. Operations for which the power too

5 forces, if proper precautions are taken. b) Never place your hand near the rotating accessory. Accessory may kickback over your hand. c) Do not pos

6 20. Before using the tool on an actual workpiece, let it run for a while. Watch for vibration or wobbling that could indicate poor installation or

7 caution when locking tool in "ON" position and maintain firm grasp on tool. 12AB 006734 For tool with the lock-on switch To start the too

8 For tool with clamp lever type wheel guard 1234 010644 12 010645 Loosen the lever on the wheel guard. Mount the wheel guard with the protrusion on

9 Mount the rubber pad onto the spindle. Fit the disc on the rubber pad and screw the lock nut onto the spindle. To tighten the lock nut, press the sh