Makita 2106K Manual de Instruções

Portable Band Saw -~ ~ ~ Max. cutting capacity Round Rectangular workpiece workpiece Without optional stand With optional stand 115 mm dia. 115 mm

MA1 NTENANCE CAUTION : Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. Cleaning A

Use a screwdriver to remove the brush I holder caps. Take out the worn carbon brushes, insert the new ones and secure the brush holder caps

ACCESSORIES CAUTION : These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any

Cutting wax Part No. 191897-9 Portable band saw stand Part No. 122370-8 (For accurate square cutting operations) Steel carrying case Part No. 823204-

Feb.-04-'88 EN PORTABLE BAND SAW Model 2106 Note: The switch, noise suppressor and other part configurations may differ from country to coun

MODEL 2106 Feb.-04-'BB US MACHlNE 50 51 52 53 54 55 56 57 58 59 60 61 62 63 641 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 BO 81 82 83 84 85

MAKCTA LIMITED ONE YEAR WARRANTY Warranty Policy Every Makita tool is thoroughly inspected and tested before leaving the factory. It is warranted to b

IMPORTANT SAFETY INSTRUCTIONS (For All Tools) WARNING: WHEN USING ELECTRIC TOOLS, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO REDUCE THE R

14. REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of checking to see that keys and adjusting wrenches are removed from tool before turning it on. 15

VOLTAGE WARNING: Before connecting the tool to a power source (receptacle, outlet, etc.) be sure the voltage supplied is the same as that specified o

Switch action To start the tool, simply pull the trigger. Release the trigger to stop. For continuous operation, pull the trigger and then push i

Installing or removing blade CAUTION : Always be sure that the tool is switched off and unplugged before installing or removing the blade. Oil on the

Position the blade around the wheels and insert the other side of the blade within the Hold the blade in place and turn the blade tightening lever

Squaring blade with stopper plate Use the triangular rule to make sure that the side of the blade is square with the side of the stopper plate. I

Hold the tool as shown in the figure with the stopper plate contacting the workpiece and the blade clear of the workpiece. Turn the tool on and wait