Makita RP1100 Manual do Utilizador

INSTRUCTION MANUALWARNING:For your personal safety, READ and UNDERSTAND before using.SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.www.makitatools.comR

10Insert the bit all the way into the collet chuck and withdraw itvery slightly ( approx. 2mm;1/16” ). Then tighten the colletchuck securely with the

11• When using the straight guide, be sure to install it on theright side in the feed direction. This will help to keep itflush with the side of the w

12To install the templet guide, insert the templet guide in centerhole in the base plate and secure in place with the lock nut.Secure the templet to t

13Use a screwdriver to remove the brush holder caps. Take outthe worn carbon brushes, insert the new ones and securethe brush holder caps.To maintain

Memo14

Memo15

Memo16

17First-ClassPostageRequiredPost Office willnot deliverwithout properpostage.Makita U.S.A., Inc.14930 Northam StreetLa Mirada, CA 90638-5753FoldCut

181. This product was purchased from:Home CenterHardware/Lumber StoreTool DistributorIndustrial SupplyConstruction SupplyOther ( )

19FACTORY SERVICE CENTERS1-800-4-MAKITARETAIN THIS PORTION FOR YOUR RECORDSARIZONA3707 E. Broadway Rd., Ste. 6 Phoenix, AZ 85040 (602) 437-2850CALIFOR

2SPECIFICATIONS• Manufacturer reserves the right to change specifications without notice.• Specifications may differ from country to country.GENERAL S

WARNINGSome dust created by power sanding, sawing, grinding, drilling, and otherconstruction activities contains chemicals known to the State of Calif

35.Avoid body contact with grounded sur-faces such as pipes, radiators, ranges andrefrigerators. There is an increased risk ofelectric shock if your b

4SERVICE23.Tool service must be performed only byqualified repair personnel. Service or main-tenance performed by unqualified personnelcould result in

5An adapter Fig. “B” and “C” is available for connecting Fig. “A” type plugs to two- prongreceptacles. The green-colored rigid ear, lug, etc., extendi

613.Do not touch the bit immediately afteroperation; it may be extremely hot andcould burn your skin.14.Always lead the power supply cord awayfrom the

7FUNCTIONAL DESCRIPTIONCAUTION:• Always be sure that the tool is switched off andunplugged before adjusting or checking function on thetool.Adjusting

8CAUTION:• Since excessive cutting may cause overload of the motoror difficulty in controlling the tool, the depth of cut shouldnot be more than 15 mm

9Speed adjusting dialFor model RP1101 onlyThe tool speed can be changed by turning the speed adjust-ing dial to a given number setting from 1 to 6.Hig