Makita 4107RH Manual de Instruções descarregar pdf (Página 5)

2. Never place your hand near the rotating wheel.

Wheel may kickback over your hand.

3. Do not position your body in line with and

behind the rotating wheel. Kickback will propel

the tool in direction opposite to the wheel's

movement at the point of snagging.

4. Use special care when working corners, sharp

edges etc. Avoid bouncing and snagging the

wheel. Corners, sharp edges or bouncing have a

tendency to snag the rotating wheel and cause

loss of control or kickback.

5. Do not attach a saw chain woodcarving blade

or toothed saw blade. Such blades create

frequent kickback and loss of control.

6. Do not "jam" the wheel or apply excessive

pressure. Do not attempt to make an

excessive depth of cut. Overstressing the wheel

increases the loading and susceptibility to twisting

or binding of the wheel in the cut and the

possibility of kickback or wheel breakage.

7. When wheel is binding or when interrupting a

cut for any reason, switch off the power tool

and hold the power tool motionless until the

wheel comes to a complete stop. Never

attempt to remove the wheel from the cut

while the wheel is in motion otherwise

kickback may occur. Investigate and take

corrective action to eliminate the cause of wheel

binding.

8. Do not restart the cutting operation in the

workpiece. Let the wheel reach full speed and

carefully reenter the cut. The wheel may bind,

walk up or kickback if the power tool is restarted

in the workpiece.

9. Support panels or any oversized workpiece to

minimize the risk of wheel pinching and

kickback. Large workpieces tend to sag under

their own weight. Supports must be placed under

the workpiece near the line of cut and near the

edge of the workpiece on both sides of the wheel.

10. Use extra caution when making a "pocket cut"

into existing walls or other blind areas. The

protruding wheel may cut gas or water pipes,

electrical wiring or objects that can cause

kickback.

SAVE THESE INSTRUCTIONS.

WARNING:

DO NOT let comfort or familiarity with product

(gained from repeated use) replace strict adherence

to safety rules for the subject product. MISUSE or

failure to follow the safety rules stated in this

instruction manual may cause serious personal injury.

FUNCTIONAL DESCRIPTION

CAUTION:

• Always be sure that the tool is switched off and

unplugged before adjusting or checking function

on the tool.

Portable residual current device

005151

Connect the tool to a power supply and test the Portable

Residual Current Device (PRCD) before using the tool.

Push the "RESET" or "ON" button and confirm that the

pilot lamp lights. Push the "TEST" button and confirm

that the pilot lamp goes out. Push the "RESET" or "ON"

button again to use the tool.

WARNING:

• Do not use the tool if the pilot lamp does not go

out when the "TEST" button is pushed.

Adjusting the depth of cut

005165

Loosen the lever on the depth guide and move the base

up or down. At the desired depth of cut, secure the base

by tightening the lever.

CAUTION:

• After adjusting the depth of cut, always tighten the

lever securely.

1. Lever

1. TEST button

2. RESET or "ON"

button

3. Pilot lamp

4. Portable

residual current

device (PRCD)

1 2 3 4 5 6 7 8 9 10 11 12

Comentários a estes Manuais

Sem comentários

Makita 4107RH Manual de Instruções Página 5

Comentários a estes Manuais

Manuais e produtos relacionados com Cortadores universais elétricos Makita 4107RH