Makita HPR2410 Manual do Utilizador

INSTRUCTION MANUALWARNING:For your personal safety, READ and UNDERSTAND before using.SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.Rotary Hammer24 mm (

10Drilling in wood or metalUse the optional drill chuck assembly. When installing it, referto “Installing or removing the bit” described on the previo

11ACCESSORIESCAUTION:• These accessories or attachments are recommended foruse with your Makita tool specified in this manual. Theuse of any other acc

Memo12

13FoldCutStampTimbreMakita Canada Inc.1950 Forbes Street,Whitby, OntarioL1N 7B7

14Your answers to the following questions are appreciated.Date Purchased Model No.Serial No.Initial Last NameStreet AddressCity ProvinceAGE:Male Femal

15Factory Service CentresFor the authorized service centre nearest you please refer to the local yellow pages directory under “tools” or con-tact our

Warranty PolicyEvery Makita tool is thoroughly inspected and tested before leaving the factory. It is warranted to be free of defects fromworkmanship

2SPECIFICATIONS• Manufacturer reserves the right to change specifications without notice.• Specifications may differ from country to country.GENERAL S

3Electrical Safety4. Double insulated tools are equipped witha polarized plug (one blade is wider thanthe other.) This plug will fit in a polarizedout

421. Check for misalignment or binding ofmoving parts, breakage of parts, and anyother condition that may affect the toolsoperation. If damaged, have

53. Wear a hard hat (safety helmet), safetyglasses and/or face shield. Ordinary eyeor sun glasses are NOT safety glasses. Itis also highly recommended

6FUNCTIONAL DESCRIPTIONCAUTION:• Always be sure that the tool is switched off andunplugged before adjusting or checking function on thetool.Switch act

7Torque limiterThe torque limiter will actuate when a certain torque level isreached. The motor will disengage from the output shaft.When this happens

8Installing or removing the bitClean the bit shank and apply bit grease before installing thebit.Insert the bit into the tool. Turn the bit and push i

9Dust cup (optional accessory)Use the dust cup to prevent dust from falling over the tooland on yourself when performing overhead drilling opera-tions