Makita 6093DW Manual de Instruções

Cordless Driver DrillEquipped with Electric Brake10 mm (318") MODEL 6093D10 mm (318") MODEL 6093DWWith Fast ChargerINSTRUCTION MANUALSPECIFI

NOTE :• Use the proper bit for the head of the screw that you wish to use.• Make sure that the driver bit is inserted straight in the screw head, or t

Overload protectorThe overload protector automatically cuts out to break the circuit whenever heavy workis prolonged. Wait 20 -30 seconds before resum

MAINTENANCECAUTION :Always be sure that the tool is switched off and the battery cartridge is removed beforeattempting to perform inspection or mainte

OPTIONAL ACCESSORIESThe accessories listed in this manual are available at an extra cost from you r Makita distributor or Makita factoryservice center

10 mm (3/8"')CORDLESS DRIVER DRILLModel 6093DDec. 25 86 EN®Note: The switch and other part configurationsmay differ from country to country.

MODEL 6093D Dec -25-'86 ENITEM NOITEM NO, DESCRIPTION DESCRIPTIONNO USED NO. USEDMACHINE1 62 23 14 25 16 27 18 I910 111 112 113 114 f15 116 117 1

MAKITA LIMITEDONE YEARWARRANTYWarranty PolicyEvery Makita tool is thoroughly inspected and tested before leaving the factory. It is waxrantad tobe fre

IMPORTANTSAFETY INSTRUCTIONS(For All Tools)WARNING: WHEN USING ELECTRIC TOOLS, BASIC SAFE-TY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TOREDUCE THE RISK O

14. REMOVEADJUSTINGKEYSANDWRENCHES.Formhabitof checkingtoseethatkeysandadjustingwrenchesareremovedfromtoolbeforeturningit on.15. AVOIDUNINTENTIONALSTA

IMPORTANT SAFETY INSTRUCTIONS1 SAVE THESE INSTRUCTIONS - Thismanualcontains important safety and operating instructions for battery charger,2. Before

ADDITIONAL SAFETY RULESFOR CHARGER & BATTERY CARTRIDGE1. Do not charge Battery Cartridge when temperature is BELOW 10°C 150°FDor ABOVE 40°C (104°F

Installing or removing battery cartridge• Always switch off the tool before insertion or removal of the battery cartridge.• To remove the battery cart

• If youwishto chargetwobatterycartridges,allow15minutesbetweenchargingsonthefastcharger.Installing or removing drill bit or driver bitCAUTION:Always

Switch actionTool speed is increased by increasing pres-sure on the trigger. To start the tool,simply pull the trigger. Release the triggerto stop.Tri

Adjusting fastening torqueThe fastening torque can be adjusted in sixstages by turning the adjusting ring so thatthe pointer on the adjusting ring poi