Makita HR2810T Manual de Instruções descarregar pdf (Página 10)

Blow-out bulb (optional accessory)

002449

After drilling the hole, use the blow-out bulb to clean the

dust out of the hole.

Chipping/Scaling/Demolition

For models HR2810, HR2810T, HR2811F, HR2811FT

only

008214

Set the action mode changing knob to the symbol.

Hold the tool firmly with both hands. Turn the tool on

and apply slight pressure on the tool so that the tool will

not bounce around, uncontrolled. Pressing very hard on

the tool will not increase the efficiency.

Drilling in wood or metal

004223

007944

007945

004224

For Model HR2800, HR2810, HR2810F

Use the optional drill chuck assembly. When installing it,

refer to "Installing or removing the bit" described on the

previous page.

Set the action mode changing knob so that the pointer

points to the

symbol.

For model HR2810T, HR2811FT

Use the quick change drill chuck as standard equipment.

When installing it, refer to "changing the quick change

chuck for SDS-plus " described on the previous page.

Hold the ring and turn the sleeve counterclockwise to

open the chuck jaws. Place the bit in the chuck as far as

it will go. Hold the ring firmly and turn the sleeve

clockwise to tighten the chuck. To remove the bit, hold

the ring and turn the sleeve counterclockwise.

Set the action mode changing knob to the

symbol.

You can drill up to 13 mm diameter in metal and up to

32 mm diameter in wood.

CAUTION:

• Never use "rotation with hammering" when the

quick change drill chuck is installed on the tool.

The quick change drill chuck may be damaged.

Also, the drill chuck will come off when reversing

the tool.

• Pressing excessively on the tool will not speed up

the drilling. In fact, this excessive pressure will

only serve to damage the tip of your bit, decrease

the tool performance and shorten the service life

of the tool.

• There is a tremendous twisting force exerted on

the tool/bit at the time of hole breakthrough. Hold

the tool firmly and exert care when the bit begins

to break through the workpiece.

1. Sleeve

2. Ring

3. Quick change

drill chuck

1. Spindle

2. Quick change

drill chuck

3. Change cover

line

4. Change cover

1. Quick change

chuck for SDS-

plus

2. Change cover

line

3. Change cover

1. Chuck adapter

2. Keyless drill

chuck

1. Blow-out bulb

1 2 ... 5 6 7 8 9 10 11 12

Comentários a estes Manuais

Sem comentários

Makita HR2810T Manual de Instruções Página 10

Comentários a estes Manuais

Manuais e produtos relacionados com Martelos rotativos Makita HR2810T