Makita GA7050 Manual de Instruções

1 ENGLISH (Original instructions) INSTRUCTION MANUAL DOUBLE INSULATION IMPORTANT: Read Before Using. Angle GrinderGA7050 GA7050R GA9050 GA9050R 01

10 For Australia and New Zealand 45102123 010654 Mount the inner flange onto the spindle. Fit the wheel/disc on the inner flange and screw the lock n

11 NOTE: • Ezynut can be loosened by hand as long as the arrow points the notch. Otherwise a lock nut wrench is required to loosen it. Insert one pin

12 Thread wire wheel brush onto spindle and tighten with the wrenches. When using wire wheel brush, avoid applying too much pressure which causes over

13 When the resin insulating tip inside the carbon brush is exposed to contact the commutator, it will automatically shut off the motor. When this occ

14 12345678910111213235678910211412113*1 Do not use Supper flange and Ezynut together.14151415*2 Use Inner flange 78 and Outer flange 78 together. (Au

15

16 Makita Corporation Anjo, Aichi, Japan 884937A223

2 ENGLISH (Original instructions) SPECIFICATIONS Model GA7050 GA7050R GA9050 GA9050R Depressed center wheel diameter 180 mm 180 mm 230 mm 230 mm

3 WARNING: • The vibration emission during actual use of the power tool can differ from the declared emission value depending on the ways in which th

4 GEA005-3 General Power Tool Safety Warnings WARNING Read all safety warnings and all instructions. Failure to follow the warnings and instruction

5 dangerous in the hands of untrained users. 22. Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any o

6 accessory could snag your clothing, pulling the accessory into your body. 14. Regularly clean the power tool’s air vents. The motor’s fan will dr

7 e) Support panels or any oversized workpiece to minimize the risk of wheel pinching and kickback. Large workpieces tend to sag under their own weigh

8 FUNCTIONAL DESCRIPTION CAUTION: • Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. Sh

9 010642 Screw the side grip securely on the position of the tool as shown in the figure. Installing or removing wheel guard (For depressed center w