Makita LS1013L Manual de Instruções

1 ENGLISH (Original instructions) INSTRUCTION MANUAL DOUBLE INSULATION WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE TH

10 Installing or removing saw blade CAUTION: • Always be sure that the tool is switched off and unplugged before installing or removing the blade. •

11 3124 001532 Dust bag (accessory) 312 001536 The use of the dust bag makes cutting operations clean and dust collection easy. To attach the dust

12 12 001549 Sub-fence 1 001545 This tool is equipped with the sub-fence which should ordinarily be positioned as shown in the figure. However, wh

13 The horizontal vise can be installed in two positions on either the left or right side of the base. When performing 15° or greater miter cuts, ins

14 force as is necessary for smooth cutting and without significant decrease in blade speed. • Gently press down the handle to perform the cut. If th

15 with the blade and PUSH THE CARRIAGE TOWARD THE GUIDE FENCE TO CUT THE WORKPIECE. When the cut is completed, switch off the tool and WAIT UNTIL THE

16 figure. Then remove the workpiece material between the grooves with a chisel. Do not attempt to perform this type of cut using wide (thick) blades

17 132 001568 2. Bevel angle (1) 0° bevel angle 132 001569 Push the carriage toward the guide fence and tighten the knob to secure the carriage.

18 Adjusting for smooth beveling action 12 004860 The hex lock nut holding together the arm and arm holder has been factory adjusted to assure smoot

19 To shift the laser line movable range further away from the side surface of blade, turn the two screws counterclockwise after loosening the adjusti

2 ENGLISH SPECIFICATIONS Model LS1013 /LS1013F/ LS1013L/LS1013FL Blade diameter 250 mm - 260 mm Hole diameter For all countries other than Europea

20 21 001576 After use • After use, wipe off chips and dust adhering to the tool with a cloth or the like. Keep the blade guard clean according to

21

22

23

24 Makita Corporation Anjo, Aichi, Japan 884098H229

3 Standard and can, therefore, also be used from sockets without earth wire. ENG102-3 Noise The typical A-weighted noise level determined according to

4 operate the tool. 13. Do not overreach. Keep proper footing and balance at all times. 14. Maintain tools with care. Keep cutting tools sharp and c

5 21. Before using the tool on an actual workpiece, let it run for a while. Watch for vibration or wobbling that could indicate poor installation or

6 GUARD OR THE SPRING WHICH ATTACHES TO THE GUARD. In the interest of your personal safety, always maintain the blade guard in good condition. Any irr

7 12 001539 213 001540 First, unplug the tool. Push the carriage toward the guide fence fully and lower the handle completely. Use the socket wren

8 CAUTION: • When tilting the saw blade, be sure to raise the handle fully. • After changing the bevel angle, always secure the arm by tightening th

9 NOTE: • Use a dry cloth to wipe the dirt off the lens of lamp. Be careful not to scratch the lens of light, or it may lower the illumination. Lase