Makita EVH2000 Manual de Instruções descarregar pdf (Página 10)

BEFORE START OF OPERATION

Inspection and Rell of Engine Oil

– Perform the following procedure, with the engine cooled down.

– While keeping the engine level, remove the oil gauge, and conrm that the oil is lled within the upper and lower limit marks.

When the oil is in short in such a way that the oil gauge touches the oil only by its tip, in particular with the oil gauge remaining inserted in the

crankcase without screwing-in (Fig. 1), rell new oil near the port (Fig. 2).

– For reference, the oil rell time is about 10h (10 times or 10 tanks of oil rell).

– If the oil changes in color or mixes with dirt, replace it with new one. (For the interval and method of replacement, refer to P 16)

Recommended oil: SAE 10W-30 oil of API Classication, Class SF or higher (4-stroke engine for automobile)

Oil volume: Approx. 0.08 L

Note: If the engine is not kept upright, oil may go into around the engine, and may be relled excessively.

If the oil is lled above the limit, the oil may be contaminated or may catch re with white.

Point 1 in Replacement of Oil “Oil Gauge”

– Remove dust or dirt near the oil rell port, and detach the oil gauge.

– Keep the detached oil gauge free of sand or dust. Otherwise, any sand or dust adhering to the oil gauge may cause irregular oil circulation

or wear on the engine parts, which will result in troubles.

– As an example to keep the oil gauge clean, it is recommended to insert the oil gauge on its knob side into the engine cover, as shown in

Fig.3.

If oil adheres around

this tip, rell new oil.

Fig.1 Fig.2

Upper limit

(Edge of oil rell port)

Fig.3

Oil gauge

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 127 128

Sem comentários

Makita EVH2000 Manual de Instruções Página 10